DigiPlus fair value

How to open the car engine compartment

The car mainly finds the power switch of the hood. Generally, on the left panel of the driver's seat, it may be a power switch pulled by hand or foot. The owner can open the hood by pulling or stepping on the power switch with his hand. After the owner presses or steps on the power switch, the hood of the car will be lifted up, leaving a gap of about 3-5 centimeters.

Specific steps: (1) First open the door, sit in the driver's seat, and then find the engine switch handle on the left side of the driver's seat. ( 2) Pull the handle of the car engine with your hand and hear a bang. ( 3) Check whether the hood of the car is open. If there is an obvious gap, it means that the hood of the car has been opened.

How to turn on the hood: The hood switches of most cars on the market basically have the same handle as the button on the driver's side lower baffle. After slowly pulling the hood, it will make a sound immediately. Then, you can find the switch sticking out of the hood and turn on the hood.

How to open the hood of Honda Accord, AccordEngine compartment diagram

Before the Honda Accord hood is opened, it needs to be unlocked in the car, and then the lever in the center of the engine compartment is unlocked for the second time to open the engine hatch. If the engine cover lock latch is difficult to move, or the engine cover can be opened without pulling the lock latch, it should be cleaned and moistened. Sliding latch mechanism.

The illustration of the front cover of the Accord is as follows: Tools: Honda Accord. Open the door on the driver's side of the Honda Accord. Pull the hood switch on the left side of the Honda Accord driver's leg. Lift the engine hood of the Honda Accord upwards.

In the position of the driver's left foot, there are two wrenches that control the hood and the trunk respectively; the buttons of the trunk and the fuel tank are integrated. Lifting up is to open the trunk, and pressing down is to open the fuel tank cover.

First, find the hood, which is located on the driver's side of the engine compartment. Second, find the four screw knees to be removed. Third, use a screwdriver to unscrew the screw knee. When all of them are removed, the hood can be successfully removed. Finally, slowly open the hood with a small handle to complete the whole opening process.

The Accord engine cover switch is in the cab, and the light switch is located below. You can open the engine cover by pulling the latch, and use the top pillar to hold the engine cover. The engine cover has the function of protecting the engine and the effect of soundproofing.

The specific operation steps are as follows: open the door on the driver's side of the Honda Accord. Pull the hood switch on the left side of the Honda Accord driver's leg. Lift the engine hood of the Honda Accord upwards.Pull the trunk switch of the Honda Accord door. Push up to open the trunk.

How to open the engine cover of Land Rover

1. The switch of the hood of Land Rover is in the car, which needs to be turned on manually, and the position of the switch is around the foot pedal. There is a switch button on the left side of the pedal. We can press the switch to open the outer hood. Put the hydraulic cylinder of the hood into the groove of the hood to support it.

2. The engine hatch switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can lift the opening handle along the arrow, lift the engine cover and open it, then remove the engine hatch support rod from its fixed bracket, and finally hang the engine hatch support rod into the display. In the groove of the motor hatch.

3. The engine hatch switch of Volkswagen Touareg is located in the lower left corner of the driver's seat. As shown in the figure below, we can lift the handle along the arrow, lift the engine hood and open it, then remove the engine hatch support rod from its fixed bracket, and finally hang the engine hood support rod into In the groove of the engine cover.